Bottom End

ARP Honda B18A / B Main Stud Kit - 208-5404. Complete with Studs, Washers, and Nuts ARP Main Stud Specs made out of premium 8740 alloy rated far superior to aircraft quality Heat treated to 200,000 psi Thread Rolled after heat treat (1000% better than studs that are thread rolled prior to heat treat Some Technical info on Studs Using studs will make it much easier to assemble an engine( especially a racing powerplant which must be serviced frequently and quickly!) with the cylinder head and gasket assured of proper alignment. Studs Provide more accurate and consistent torque loading ( When you use bolts to secure the head, the fastener is actually being twisted while it's being torqued to the proper reading. acordingly, the bolt is reacting to two different forces simultaneously. A stud should be installed in a relaxed mode - never crank it in tightly using a jammed nut. If everything is right, the studs should be installed finger thight. Then, when applying torque to the nut, the stud will stretch only on the vertical axis. Tech Tips: Main Stud Installation Clean and chase appropiate threads in block to ensure proper thread engagment and accurate torque readings All hardware (and caps) should be cleaned and inspected prior to installation, looking for any shipping damage or defects Screw studs into block, finger thights ONLY. For permanent installation, apply loc-tite sparingly to threads. Be sure and install the caps promptly before the cement sets to prevent misalignment of studs in block. Install main caps, checking for binding and misalignment. lubricate threads, nuts and washers with oil or arp moly assembly lubricant before installation. Note that torque specs will vary by lubricant. moly lube is more consistent. Have block align honed. Usins the instructions provided with the studs, tighten the nuts to proper torque values three times. NOTE: if using Loc-tite proper preload must be achieved prior to it setting up. Learn More

K1 Honda B18A/B Connecting Rods - HH5394ACFB4-A Billet 4340 Steel H Beam connecting rods. Closely monitored material mechanical properties for optimum performance. Designed and finish honed in the USA. Sizes held to some of the tightest tolerances in the industry, +/- .0001” and +/- 1 gram per end. Shot peened for improved fatigue life. Bronze wrist pin bushings. Exclusively using ARP 2000 fasteners. Learn More

Forged pistons set for the Acura/Honda Integra B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Integra, 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Integra 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Acura Integra 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Acura Integra 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Acura Integra 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More

Forged pistons set for the Acura Integra 1990-00 B18A1/B1, includes all rings, pins and clips needed for installation. Learn More